[ANSYS Meshing] Meshing parallel -- CFD Online Discussion Forums

January 3, 2019, 18:36	Meshing parallel	#1
Andrea159357 Member Andrea Join Date: Mar 2018 Posts: 62 Rep Power: 8	Hello, i'm stuck with a problem; i know that i need to split my geometry to run parallel meshing but i cannot do it if i share topology in Spaceclaim. ANSYS MESHING see just one part. My question is simple: "Can i get CONFORMAL MESH even without sharing faces in Spaceclaim?" I have made some test with simple geometry and i get a beautiful conformal mesh even without sharing. Is this the same for complex geometry?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error running simpleFoam in parallel	Yuby	OpenFOAM Running, Solving & CFD	14	October 7, 2021 04:38
The problem when i use parallel computation for mesh deforming.	Hiroaki Sumikawa	OpenFOAM Running, Solving & CFD	0	November 20, 2018 02:58
chtMultiRegionSimpleFoam: crash on parallel run	student666	OpenFOAM Running, Solving & CFD	3	April 20, 2017 11:05
[Gmsh] 3D coil mesh: can't create the volume?	RomainBou	OpenFOAM Meshing & Mesh Conversion	3	July 18, 2016 05:09
Parallel meshing using XP64 with PVM in CFX Mesh	Huw	ANSYS Meshing & Geometry	4	July 12, 2010 10:24

All times are GMT -4. The time now is 16:51.