|
[Sponsors] |
January 20, 2019, 03:10 |
Cooling Holes
|
#1 |
New Member
serg
Join Date: Dec 2015
Posts: 28
Rep Power: 10 |
Hi, I was wondering if i can mesh a stator vane with holes located over the surface, for example showerhead holes located near the leading edge or as in tip cooling holes over the tip floor in turbines.
I am new to ICEM, trying to learn it from videos on the internet and i did not find any turbomachinery tutorial with additional surfaces over the airfoil. Any help is appreciated. S. |
|
January 22, 2019, 17:34 |
|
#2 |
Senior Member
Gert-Jan
Join Date: Oct 2012
Location: Europe
Posts: 1,827
Rep Power: 27 |
Your question is something like:
'I have seen a car and want to build one. Who can tell me how?' Don't expect answer from this kind of questions. You to be much more specific on the problems you encounter in ICEM...... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Meshing a flat plate with cooling holes with a plenum using Centaur as a Meshing tool | TheStudent | ANSYS Meshing & Geometry | 0 | March 13, 2017 09:58 |
[ICEM] ribbed passage with cooling holes | raorp | ANSYS Meshing & Geometry | 2 | September 25, 2013 09:37 |
modeling cooling holes in turbine blades | rajesh kumar gupta | Main CFD Forum | 1 | September 9, 2010 12:13 |
Unbelievably high velocity magnitudes in film cooling - HELP! | shankara.2 | FLUENT | 0 | June 1, 2009 22:43 |
Passive cooling system for batch reactor | Darek | Main CFD Forum | 0 | September 30, 2003 05:06 |