Meshing a fin
Dear all,
I'm trying to do a simple simulation of fin but I have got stuck doing the mesh. I'm getting errors all the time and I'm not sure why. The geometry of the fin is very fine, it is made of 83481 faces (see attached figure). The errors and warnings I'm getting in Meshing are of the type:
I'm using a sizing for the fin with a size element of 0.1 mm (the fin is 100 mm length, 150 mm height and 5 mm thick at the base). Is there a way to simplify the fin geometry? If anybody can give me an advise I will appreciate it. Kind regards, https://i.ibb.co/bBZ7vP6/Fin-1.jpg https://i.ibb.co/0r1Z7CP/Fin-2.jpg |
I am facing a similar problem. Did you find any solution?
|
All times are GMT -4. The time now is 00:19. |