 |
 |
 |
|
|
|
[Sponsors] | ||||
[ICEM] Total thickness of prism layers in a circular pipe |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 11, 2019, 12:31
|
Total thickness of prism layers in a circular pipe
|
#1 |
|
New Member
Przemek
Join Date: Feb 2010
Location: Warsaw Poland
Posts: 27
Rep Power: 16  |
Hi,
assuming that in fully developed turbulent flow in a circular pipe, boundary layer occupies whole diameter (BL merges at centerline). Is there any rule of thumb what should be the total thickness of the inflation layer? Thanks, Przemek |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Prism Layer (Boundary Layer) Thickness | Peter-27 | STAR-CCM+ | 12 | March 27, 2022 12:25 |
| Total Thickness of Inflation Layer | prikeyma | CFX | 5 | August 28, 2020 03:22 |
| total pressure change in a pipe flow | Im | FLUENT | 5 | February 23, 2017 08:55 |
| Trimmed Cell Mesher and Prism Layers | Jack220 | STAR-CCM+ | 4 | August 7, 2013 10:57 |
| Getting prism to inflate into mixed tet-hex meshes | Joe | CFX | 16 | October 10, 2011 07:06 |
Linear Mode
