 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] Want to mesh 2D wind tunnel (rectangle) in different parts |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 9, 2019, 17:13
|
Want to mesh 2D wind tunnel (rectangle) in different parts
|
#1 |
|
New Member
Shubh
Join Date: Jul 2019
Posts: 5
Rep Power: 8  |
I am meshing the airfoil in a rectangular box. I want to partition the rectanglular box into small small different sizes and mesh it accordingly. I used boolean operation and after that sucked. How to draw the partition lines in design modeler so that it can be used to mesh in Ansys in different parts in a single file.
|
|
|
|
|
|
July 20, 2019, 04:19
|
|
#2 |
|
Member
MIDHUN
Join Date: Nov 2012
Location: calicut
Posts: 47
Rep Power: 15  |
draw a new sketch .. make lines in sketch as how u want to partition .. use lines from sketches option ... then use projection to split the geom
|
|
|
|
|
|
|
| Tags |
| ansys meshing, design modeler |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Why wind tunnel experiment and CFD domain are different? | misospider | OpenFOAM | 1 | February 6, 2017 05:31 |
| [ANSYS Meshing] Assigning different mesh densities for different parts in ANSYS ICEMCFD Tetra Mesher | johnnydrama7 | ANSYS Meshing & Geometry | 0 | September 19, 2016 14:10 |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
| mesh generation for wind tunnel | Waleedooo | Mesh Generation & Pre-Processing | 11 | March 19, 2013 19:36 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 22:11 |
Linear Mode
