[ANSYS Meshing] Making mesh sweepable

spelletier · June 19, 2019, 01:23

Hello all! I have attached below a section of mesh that I would like to sweep. I would like body 1 and 2 to be a single swept section all the way to body 3 and then to attach at the top When I have body 1 and 2 as a single body I am not able to sweep them and when they are separate I am only able to sweep body 1. This indicates to me that protrusions #4 are preventing sweeping in body 2 even though they are separate bodies...

Is there any way around this problem? I would like to sweep all of bodies 1 and 2 and have them connect to bodys 4.

thank you for any advice!

MaherEid · July 28, 2019, 05:11

Hello,

Have you tried to form a new part from bodies 1, 2, and 4 and use a multizone method on those bodies?
Also if you are not already using the multizone method, try it before forming a new part.

Let me know if it works

Gweher · July 30, 2019, 05:34

Hi Sebastian,

As Maher suggested I would also try the multizone method. If it fails to generate then you need to go back in the CAD geometry creator and segment the geometry in sub-parts that are sweepable (you can already check in meshing tab > rmb > show sweepable bodies -> if they are not highlighted you need to prepare the geometry better).

Have fun

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] funkyDoCalc with OF2.3 massflow	NiFl	OpenFOAM Community Contributions	14	November 25, 2020 03:30
Help for the small implementation in turbulence model	shipman	OpenFOAM Programming & Development	25	March 19, 2014 10:08
Mesh motion with Translation & Rotation	Doginal	CFX	2	January 12, 2014 06:21
[swak4Foam] build problem swak4Foam OF 2.2.0	mcathela	OpenFOAM Community Contributions	14	April 23, 2013 13:59
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55

July 28, 2019, 05:11		#2
MaherEid New Member M.Eid Join Date: Apr 2018 Posts: 27 Rep Power: 8	Hello, Have you tried to form a new part from bodies 1, 2, and 4 and use a multizone method on those bodies? Also if you are not already using the multizone method, try it before forming a new part. Let me know if it works

July 30, 2019, 05:34		#3
Gweher Senior Member Gwenael H. Join Date: Mar 2011 Location: Switzerland Posts: 392 Rep Power: 20	Hi Sebastian, As Maher suggested I would also try the multizone method. If it fails to generate then you need to go back in the CAD geometry creator and segment the geometry in sub-parts that are sweepable (you can already check in meshing tab > rmb > show sweepable bodies -> if they are not highlighted you need to prepare the geometry better). Have fun