Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[TurboGrid] Hub and shroud offset of export points of an axial stator of a turbine

Updated Threads

Reply

Search this Thread

January 26, 2017, 21:58	Hub and shroud offset of export points of an axial stator of a turbine	#1
Ahmed Saeed Mansour Senior Member Have a nice time! Join Date: Feb 2016 Location: mech.eng.ahmedmansour@gmail.com Posts: 291 Rep Power: 11	Hello, I have a stator blade and i want to use turbogrid for meshing, the blade height is 3.45 mm and i found that I cannot export the points with this small height, after increasing it to 30 mm I found no problem and the hub/shroud offset was 5.9% and this is ok...Any idea to generate the mesh with the 3.45 mm height? Thanks

May 27, 2020, 09:53		#2
michaelsinaga New Member Michael Jeremy Join Date: Jan 2020 Posts: 8 Rep Power: 6	hey how can you reduce the hub/shroud offset ? ive got a problem with too large of it.

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
[DesignModeler] Define FlowPath for axial turbine	giangcoikx	ANSYS Meshing & Geometry	1	September 29, 2016 18:06
[TurboGrid] Wind turbine: problem with the hub radius	MrDaimon	ANSYS Meshing & Geometry	0	March 12, 2015 08:12
[TGrid] Water Turbine meshed in TurboGrid: Geometry and Topology issues	ama294	ANSYS Meshing & Geometry	12	September 29, 2014 13:23
How is Hub to Shroud Line drawn in CFX by default?	arunraj	CFX	0	October 14, 2011 07:36

All times are GMT -4. The time now is 20:58.