|
[Sponsors] |
January 18, 2020, 08:15 |
Surface Mesh Problem
|
#1 |
New Member
Raditya Wiranegara
Join Date: Aug 2009
Location: United Kingdom
Posts: 22
Rep Power: 16 |
Dear All,
I'm having a problem with my generated mesh. The attached pictures describe the problem. These are periodic faces. It didn't give me an error on the 'Periodic Face' check. However, it gave me a problem when I tried to inflate prism layers. The error stated open edges encountered. Any suggestions on the possible approach to alleviating this problem? Many thanks! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh Internal Mesh problem | tenichols19 | OpenFOAM Meshing & Mesh Conversion | 2 | October 2, 2019 07:39 |
Cluster ID's not contiguous in compute-nodes domain. ??? | Shogan | FLUENT | 1 | May 28, 2014 15:03 |
[ICEM] How to generate sunstructured "all-tri patch-dependant" surface mesh in ICEM? | jash | ANSYS Meshing & Geometry | 19 | July 23, 2013 18:48 |
[snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |