|
[Sponsors] |
[ANSYS Meshing] There is not "cancel" option in (AWUMS) panel |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 9, 2020, 13:45 |
There is not "cancel" option in (AWUMS) panel
|
#1 |
Senior Member
Aja
Join Date: Nov 2013
Posts: 496
Rep Power: 14 |
Hi,
As you see in the following pic, there is not "cancel" option in Ansys Workbench Update Model Status(AWUMS) panel. Why? How can I fix? http://uupload.ir/files/nomp_cccc.png Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
Error in Two phase (condensation) modeling | adilsyyed | CFX | 15 | June 24, 2015 19:42 |
Compression stoke is giving higher pressure than calculated | nickjuana | CFX | 62 | May 19, 2015 13:32 |
An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |