 |
 |
 |
|
|
|
[Sponsors] | ||||
February 19, 2020, 03:14
|
to selected edges in icem
|
#1 |
|
New Member
saeedeh.hamoudi
Join Date: Feb 2020
Posts: 2
Rep Power: 0  |
I work on a structured mesh and nodes each edges individually, although the copy option is inactive, but nods again to parallel edges for the same number. Someone has a solution to this problem.
Thank you |
|
|
|
|
|
February 19, 2020, 08:45
|
|
#2 |
|
Senior Member
Sebastian Engel
Join Date: Jun 2011
Location: Germany
Posts: 566
Rep Power: 20 |
Hi Saeedeh,
in a structured mesh parallel edges must have the same number of elements. If you modify an edge, it will copy the new number of elements to all parallel edges. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] SHM Layer Addition Phase | dickcruz | OpenFOAM Meshing & Mesh Conversion | 4 | November 1, 2018 07:05 |
| [surface handling] surfaceFeatureExtract fails to generate .eMesh file from .stl file | buckleup | OpenFOAM Meshing & Mesh Conversion | 1 | August 24, 2018 09:44 |
| Aligned edges in ICEM | RichardG | ANSYS Meshing & Geometry | 28 | March 14, 2017 11:40 |
| [snappyHexMesh] problems using snappyHexMesh 2.1.0 on a supercomputer | Sunxing | OpenFOAM Meshing & Mesh Conversion | 9 | September 20, 2014 09:30 |
| Delete block edges in ICEM CFD | YK | CFX | 1 | June 22, 2008 14:30 |
Linear Mode
