asking about multi domain conformal mesh in Ansys Meshing 17.2
 

Dear all,



I want to simulate heat transfer in corrugated coil tube in Ansys Meshing 17.2. The fluid domain in split in two small domain to make mesh easy and the solid domain. I have problem with conformal mesh in Fluid domain. Actually, I have tried this for fluid domain only by use this tutorial https://youtu.be/N-eOwfYiysE however, when I use three domains 2 fluids and 1 solid, the meshing is not conform in fluid domains. I use shared topology in Design Modeller to make these three domains to share the topology into one. Is the conformal mesh in shared topology can be applied only fluids zone?

Do you have any suggestion?

Thank you

Best regards

Teguh