[ICEM] create surface "bug"

lbj007 · May 23, 2020, 21:40

when I create points,curves,and use the method of "from curves" to create surface,it shows many points I didn't create before,can anyone explain it?

lbj007 · May 27, 2020, 02:30

anyone knows?

sapujapu · May 27, 2020, 03:28

Sometimes, "create from curves" doesn't work when you select too many curves or the inscribed geometry is too complicated for ICEM. Try creating surfaces by smaller, individual surfaces.

lbj007 · May 28, 2020, 20:37

Quote:

Originally Posted by sapujapu

Sometimes, "create from curves" doesn't work when you select too many curves or the inscribed geometry is too complicated for ICEM. Try creating surfaces by smaller, individual surfaces.

OK,I guess that's the reason，too.Thanks for replying

May 23, 2020, 21:40	create surface "bug"	#1
lbj007 Senior Member Join Date: Feb 2020 Posts: 114 Rep Power: 6	when I create points,curves,and use the method of "from curves" to create surface,it shows many points I didn't create before,can anyone explain it?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cannot Create Surface from sliding interface zone, Create empty surface	onn83	FLUENT	4	February 22, 2024 19:02
[snappyHexMesh] snappyHexMesh can't create refimenet region	clktp	OpenFOAM Meshing & Mesh Conversion	3	February 27, 2022 09:26
[snappyHexMesh] How to create internal boundaries using snappyHexMesh	robyTKD	OpenFOAM Meshing & Mesh Conversion	2	October 19, 2014 09:57
Create a curved surface/ plane in fluent ?	tarkesdora	FLUENT	1	September 15, 2014 14:04
[Gmsh] boundaries with gmshToFoam‏	ouafa	OpenFOAM Meshing & Mesh Conversion	7	May 21, 2010 12:43

May 27, 2020, 02:30		#2
lbj007 Senior Member Join Date: Feb 2020 Posts: 114 Rep Power: 6	anyone knows?

May 27, 2020, 03:28		#3
sapujapu New Member Join Date: Feb 2020 Posts: 10 Rep Power: 6	Sometimes, "create from curves" doesn't work when you select too many curves or the inscribed geometry is too complicated for ICEM. Try creating surfaces by smaller, individual surfaces.