 |
 |
 |
|
|
|
[Sponsors] | ||||
[ICEM] Help ICEM 3D cylinder with no holes baffles at an angle |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 30, 2020, 02:03
|
Help ICEM 3D cylinder with no holes baffles at an angle
|
#1 |
|
New Member
Bola
Join Date: Mar 2020
Posts: 5
Rep Power: 6  |
Hi friends
I have been trying to mesh a 3D cylinder with the baffles at an inclination angle of 15 degrees however it has recently been proving rather difficult to do. The meshing around the baffles needs to be fine to represent the near wall regions. I have attached the geometry and I'm hoping for anyone to help with this. I would really appreciate any help Kind Regards Famous Last edited by Famous; May 30, 2020 at 08:40. |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Holes in complex ICEM geometry | alecbann | ANSYS Meshing & Geometry | 2 | April 4, 2019 03:40 |
| [ICEM] ICEM - holes in geometry | cyln | ANSYS Meshing & Geometry | 0 | November 13, 2016 22:17 |
| meshing on cylinder fails ICEM | potac | ANSYS Meshing & Geometry | 0 | October 25, 2011 05:21 |
| [Netgen] Import netgen mesh to OpenFOAM | hsieh | OpenFOAM Meshing & Mesh Conversion | 32 | September 13, 2011 05:50 |
| angle of attack with icem hexa | icem beginner | Main CFD Forum | 0 | December 5, 2008 16:54 |
Linear Mode
