|
[Sponsors] |
[ANSYS Meshing] Inflation layer cut cell meshing |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 21, 2020, 18:22 |
Inflation layer cut cell meshing
|
#1 |
New Member
Join Date: Jun 2020
Posts: 1
Rep Power: 0 |
Dear sir
i am a masters student at the university of akron and for my thesis ansys meshing software with cut cell meshing is utilized for 3d meshing around the cylinder placed on top of a plane wall. I am experiencing some issues with the generation of inflation layers around the domain link given below is a google drive link to the word document explaining this issue. https://drive.google.com/file/d/1cwe...ew?usp=sharing The mesh in the fine mesh region 0.004m and 0.1m is the size of the coarse mesh. 30 inflation layers are to be generated around the domain with cut cell assembly meshing approach. Reynolds number of the flow is 5.3*10^5 and the y+ for the inflation layer is calculated accordingly. Thank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
y+ = 1 boundary layer mesh with snappyHexMesh | Arzed23 | OpenFOAM Running, Solving & CFD | 6 | November 23, 2022 15:15 |
[mesh manipulation] createpatch not working when using layer addition in snappyHexMesh | Dikkeunit | OpenFOAM Meshing & Mesh Conversion | 0 | February 3, 2020 09:46 |
[snappyHexMesh] gaps for close surfaces- meshing with sHM | jango | OpenFOAM Meshing & Mesh Conversion | 0 | November 28, 2016 02:10 |
[snappyHexMesh] Meshing connections of round and straight edges | JShnyder | OpenFOAM Meshing & Mesh Conversion | 0 | April 24, 2016 11:25 |
[snappyHexMesh] snappyhexmesh cell splitted ununiform..2D case | sharonyue | OpenFOAM Meshing & Mesh Conversion | 1 | April 22, 2013 23:34 |