Bad quality mesh when using inflation
 

Dear all,

I am learning to mesh and run FLUENT simulations as part of my bachelors thesis. I just know few options and I am learning by attempting and failuere but at this point I am quite lost with the problem following problem.

I am meshing a stator of a fan and I am very interested in the behavior of the flux at the walls. I tried to insert an inflationon the wall but I get some bad quality cells in terms of skewness (the region where tetraedric cells, yeah I use them as default, mix with the rectangles from the inflation).

How can I solve it? Any suggestions? Thank you all in advance!

https://www.linkpicture.com/view.php...9f971992778990

https://www.linkpicture.com/view.php...0125e975173227

https://www.linkpicture.com/view.php...5bb11229606974