|
[Sponsors] |
November 12, 2020, 19:45 |
High Aspect Ratio BL Elements
|
#1 |
New Member
Join Date: Aug 2019
Posts: 14
Rep Power: 6 |
Setting the 1st node wall distance corresponding to y_plus = 1 results in extraordinarily large aspect ratios (7000). Something appears to being going wrong as doubling the 1st node wall distance yields an appropriate max aspect ratio (AR) of 300.
Increasing the node count in the streamwise or spanwise direction is not an option available to me. The "project to bsplines" setting is already enabled; when disabled, the max AR is greater than 1,000,000. |
|
November 29, 2020, 01:51 |
Please Clarify Question
|
#2 |
Senior Member
Kira
Join Date: Nov 2020
Location: Canada
Posts: 435
Rep Power: 8 |
Hello Riley,
Could you please clarify what you are asking? It is not clear. Are you asking why this is occurring or how to fix it? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
potentialFoam sensitivity to high aspect ratio cells | wind_tunnel_contraction | OpenFOAM Running, Solving & CFD | 0 | November 6, 2019 05:00 |
[ANSYS Meshing] high aspect ratio | mhdmk | ANSYS Meshing & Geometry | 1 | October 12, 2014 19:54 |
pressure eq. "converges" after few time steps | maddalena | OpenFOAM Running, Solving & CFD | 69 | July 21, 2011 07:42 |
High Aspect Ratio elements | Flavio | CFX | 2 | November 24, 2006 12:01 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |