 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] Undetected internal walls for a radiator |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 20, 2020, 14:01
|
Undetected internal walls for a radiator
|
#1 |
|
New Member
Manuel
Join Date: Dec 2020
Posts: 10
Rep Power: 5  |
I want to model a radiator, to use it as a pressure jump, inside a duct. I have my simplified radiator model and my geometry.After meshing I cannot turn the faces into an internal boundary condition
|
|
|
|
|
|
December 29, 2020, 14:55
|
solved
|
#2 |
|
New Member
Manuel
Join Date: Dec 2020
Posts: 10
Rep Power: 5 |
hello I was able to solve it, if any of you are struggling with the same send me a message.
|
|
|
|
|
|
|
March 8, 2021, 10:37
|
|
#3 |
|
New Member
Iharshavardhan reddy
Join Date: Dec 2020
Posts: 17
Rep Power: 5 |
Why we have to use the internal wall option?
Please explain to me about the split wall command in ICEM Thanks in advance. |
|
|
|
|
|
|
| Tags |
| boundary condition, design modeler, fluent, pressure jump, radiator |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] Internal Walls | balkrishna | OpenFOAM Meshing & Mesh Conversion | 7 | September 11, 2019 17:04 |
| Possible to create cyliner baffle (internal) using topoSet or stl Mesh? | keepfit | OpenFOAM | 4 | February 19, 2017 14:40 |
| [Gmsh] Generating multiple internal walls using gmshToFoam | rendagar | OpenFOAM Meshing & Mesh Conversion | 2 | October 20, 2014 03:56 |
| [ICEM] Dealing with thin internal walls in geomety | FreeFall79 | ANSYS Meshing & Geometry | 4 | November 13, 2013 11:16 |
| Heat Flux at Internal walls or Fluid Solid Interface | Mahi | CFX | 3 | October 1, 2012 02:18 |
Linear Mode
