|
[Sponsors] |
December 30, 2020, 00:13 |
ICEM does not show the Premesh
|
#1 |
Senior Member
mohammad
Join Date: Dec 2010
Location: UK
Posts: 245
Rep Power: 16 |
Hello Experts and happy new year
I am meshing a series of airfoils with some small differences. I have imported a new geometry (parasolid: *.xt) into an existing ICEM file ( and replaced the geometry with the existing one). Then I did all the associations again. The edges are fine and associations are correct and there is no error. However, I cannot see PREMESH. (NOTE THAT THE PREMESH EXISTS, SINCE I CAN CONVERT IT TO AN UNSTRUCTURED MESH, BUT THE SOFTWARE DOES NOT SHOW IT). Does anyone know how to display the PREMESH (in 2019-R3)? Best regards, |
|
December 30, 2020, 01:46 |
|
#2 |
Senior Member
Kira
Join Date: Nov 2020
Location: Canada
Posts: 435
Rep Power: 8 |
Hello,
Is the box beside the Pre-Mesh in the Blocking tree checked off? |
|
December 30, 2020, 01:50 |
|
#3 |
Senior Member
mohammad
Join Date: Dec 2010
Location: UK
Posts: 245
Rep Power: 16 |
I have checked it..it was already ticked...
The solution was to associate faces as well. Thanks for your help in responding. |
|
December 30, 2020, 01:53 |
|
#4 |
Senior Member
Kira
Join Date: Nov 2020
Location: Canada
Posts: 435
Rep Power: 8 |
Hello Mohammad,
Good show, that was to be my next suggestion. All the best. |
|
Tags |
icem, imported geom, premesh |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] The ICEM Guide for CFX Users | JuPa | ANSYS Meshing & Geometry | 11 | September 4, 2017 09:43 |
Cannot update new.3dm file in ICEM based on rpl file | jimmy871013 | Mesh Generation & Pre-Processing | 1 | June 20, 2017 02:21 |
[ICEM] complex 2D meshing on ICEM | kassab | ANSYS Meshing & Geometry | 26 | April 14, 2014 21:02 |
[ICEM] icem dosent show the mesh | feizaghaee | ANSYS Meshing & Geometry | 0 | June 20, 2010 11:16 |
ICEM CFD 5.1 Hex-Tet mesh merging failure | bogesz | CFX | 1 | January 29, 2005 06:46 |