 |
 |
 |
|
|
|
[Sponsors] | ||||
[Other] Assigning two faces separate NS on same surface |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 6, 2021, 08:49
|
Assigning two faces separate NS on same surface
|
#1 |
|
Member
Join Date: Jan 2018
Posts: 34
Rep Power: 9  |
Hello all,
I am trying to assign NS to two faces on the same surface within Solidworks, but am not able to do so. The blue region without the circle is to be plate-walls while the circle should be inlet. If I do not define these two then there is an overlapping on the fluent import. Could anyone suggest how can I make the circle, as a separate surface, while the remaining as a separate clickable surface? |
|
|
|
|
|
| Tags |
| named selections, overlapping, surfaces |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] No generation of layer onto zerothickness surface | crubio.abujas | OpenFOAM Meshing & Mesh Conversion | 3 | October 25, 2022 04:20 |
| [snappyHexMesh] Error snappyhexmesh - Multiple outside loops | avinashjagdale | OpenFOAM Meshing & Mesh Conversion | 53 | March 8, 2019 10:42 |
| [OpenFOAM.org] OF2.3.1 + OS13.2 - Trying to use the dummy Pstream library | aylalisa | OpenFOAM Installation | 23 | June 15, 2015 15:49 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 22:11 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 13, 2001 00:19 |
Linear Mode
