 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] Slice tool is not working in design modeler |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 25, 2021, 05:33
|
Slice tool is not working in design modeler
|
#1 |
|
New Member
Gaurav Kumar
Join Date: Jan 2018
Location: Delhi
Posts: 17
Rep Power: 8  |
Hello,
I am using design modeler to do slice operation of the geometry imported from solidworks to create different surface for wire and rod as shown in figure. But the slice operation is working for clockwise wrapping and not for anti-clockwise wrapping. Please suggest what should I do? |
|
|
|
|
|
September 27, 2021, 22:47
|
|
#2 |
|
Senior Member
Erik
Join Date: Feb 2011
Location: Earth (Land portion)
Posts: 1,167
Rep Power: 23 |
mirror the geometry which works if everything else is the same (rotate if needed)
|
|
|
|
|
|
|
| Tags |
| design modeler |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [DesignModeler] Rotating an imported part in Design Modeler | mikko | ANSYS Meshing & Geometry | 2 | November 30, 2015 00:23 |
| [DesignModeler] How to write the script in the ansys design modeler? | deddy1973 | ANSYS Meshing & Geometry | 3 | October 4, 2013 05:08 |
| Problem Regarding Importing Carbon Nanotube Structure IN design modeler | rhythm_saini | ANSYS | 0 | July 4, 2012 03:34 |
| design modeler | zikozaki01 | FLUENT | 4 | May 30, 2012 17:17 |
| Design Modeler to ICEM..... | Joe | CFX | 0 | January 24, 2008 03:39 |
Linear Mode
