|
[Sponsors] |
October 13, 2021, 05:12 |
Mesh generation in Fluent
|
#1 |
New Member
suna
Join Date: Oct 2021
Posts: 6
Rep Power: 4 |
Hello,
An urgent suggestion is needed from the members regarding Ansys meshing. After mesh formation, vertical lines are coming out in inclined form and throughout the airfoil it is in inclination form in C shaped domain. In case of other people's meshing, I have seen at first the vertical mesh comes in an inclined way and then it forms as vertically from middle part of airfoil till end part of it in C shaped domain. In my case, it is in inclined form throughout the c shaped domain. Why this happens in my case? Will there be any problem in getting accurate results? I have attached my mesh image and other peoples mesh image. Please help everyone! Thanks! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh/splitMeshRegion : region1 in zone "-1" | GuiMagyar | OpenFOAM Meshing & Mesh Conversion | 3 | August 4, 2023 13:38 |
Mesh generation in Fluent | suna | FLUENT | 2 | October 13, 2021 06:35 |
[snappyHexMesh] non uniform mesh near the stl object | vava10 | OpenFOAM Meshing & Mesh Conversion | 0 | January 31, 2021 15:41 |
mesh generation for in-cylinder fluent simulation | hennas | ANSYS Meshing & Geometry | 2 | May 31, 2011 16:08 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |