 |
 |
 |
|
|
|
[Sponsors] | ||||
October 22, 2021, 07:27
|
Domain problem
|
#1 |
|
New Member
Join Date: Oct 2021
Posts: 6
Rep Power: 4  |
Hey guys,
I'm new to ICEM. I have a geometry with part of the geometry outside the main FLUID domain. This FLUID domain has an inlet and outlet, which connect to the outside geometry through two pipes. As you may have guessed since the FLUID domain is already bounded by surfaces it does not generate the mesh in the outside geometry. Is there any way of generating the mesh without creating a separate FLUID domain for the outside geometry? Thanks you for your help! 
|
|
|
|
|
 |
| Tags |
| domain interface, icem |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CFX - specified domain intialization | qntldoql | CFX | 4 | September 28, 2020 09:28 |
| Sudden increase the residual of Maxwell's equations | hsezsz | CFX | 2 | October 13, 2016 06:58 |
| Domain Imbalance | HMR | CFX | 5 | October 10, 2016 05:57 |
| Monte Carlo Simulation: H-Energy is not convergating & high Incident Radiation | volleyHC | CFX | 5 | April 3, 2016 05:41 |
| Pressure distribution on a wall | darazsbence | CFX | 17 | October 6, 2015 10:38 |
Linear Mode
