[ANSYS Meshing] Structural Grid Meshing not consistent

Qkarl · June 12, 2022, 11:22

Hi All,

I'm try to do a structure mesh by using edge sizing, however the outcome i got is not consistent, where i can get most of my model is structured mesh, but part of them, are unstructured or not to my expectation. did anyone encounter this before and how to resolve it? please see the photo in the attachment

Gert-Jan · June 15, 2022, 04:55

Using your RMB on the Mesh-item in the tree on the left, you should ask the WB-mesher to show sweepable bodies. If the solid is not sweepable, it will not make a structured mesh.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] ICEM Meshing Problem-2D Unstructured	Tariq Ahmed	ANSYS Meshing & Geometry	0	August 25, 2016 16:13
[Gmsh] Gmsh error while meshing a 3d grid?	tareqkh	OpenFOAM Meshing & Mesh Conversion	0	July 6, 2016 15:39
Need help with meshing 3D jet nozzle grid on ICEM	Jay1	CFD Freelancers	2	March 21, 2016 05:55
[Other] Turbo grid Splitter meshing	vitulaaak	ANSYS Meshing & Geometry	5	October 17, 2012 08:31
Grid adaption or Gambit meshing?	ravi varma	FLUENT	8	December 12, 2002 13:09

June 15, 2022, 04:55		#2
Gert-Jan Senior Member Gert-Jan Join Date: Oct 2012 Location: Europe Posts: 1,823 Rep Power: 27	Using your RMB on the Mesh-item in the tree on the left, you should ask the WB-mesher to show sweepable bodies. If the solid is not sweepable, it will not make a structured mesh.