[ANSYS Meshing] Extruding multiblock meshes on ICEM

vauntedmango · November 11, 2021, 11:11

Hello,

I am trying to create a multiblock quasi-3D mesh by creating a 2D mesh and extruding it in the k-direction. However, I found that the extrude mesh option on ICEM is greyed out unless converting the mesh into an unstructured mesh. I tried to do this and extrude it which worked, but when trying to convert the mesh back to multiblock, it removes the extrusion and goes back to 2D. Anyone know how to work around this?

ramkr · June 11, 2022, 04:43

I also have this exact same issue! Want to extrude a 2D structured multi-block mesh of ICEM-CFD into a 3D grid. Very badly need assistance on this.

November 11, 2021, 11:11	Extruding multiblock meshes on ICEM	#1
vauntedmango New Member Join Date: Mar 2021 Posts: 13 Rep Power: 5	Hello, I am trying to create a multiblock quasi-3D mesh by creating a 2D mesh and extruding it in the k-direction. However, I found that the extrude mesh option on ICEM is greyed out unless converting the mesh into an unstructured mesh. I tried to do this and extrude it which worked, but when trying to convert the mesh back to multiblock, it removes the extrusion and goes back to 2D. Anyone know how to work around this?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] The ICEM Guide for CFX Users	JuPa	ANSYS Meshing & Geometry	11	September 4, 2017 09:43
[ICEM] complex 2D meshing on ICEM	kassab	ANSYS Meshing & Geometry	26	April 14, 2014 21:02
ICEM 2d multiblock	JTDN	ANSYS	1	June 25, 2013 19:26
[ICEM] Meshing adjacent wall geometry and simple ICEM questions	everdimension	ANSYS Meshing & Geometry	25	June 20, 2012 04:25
Joining Meshes in Ansys ICEM CFD	Amitava Guha	FLUENT	2	April 22, 2008 13:35

June 11, 2022, 04:43		#2
ramkr New Member S Ram Kumar Join Date: Jan 2019 Location: India Posts: 12 Rep Power: 7	I also have this exact same issue! Want to extrude a 2D structured multi-block mesh of ICEM-CFD into a 3D grid. Very badly need assistance on this.