|
[Sponsors] |
September 21, 2022, 00:45 |
Issue while extruding blocks
|
#1 |
Senior Member
Lolita
Join Date: Aug 2016
Posts: 115
Rep Power: 9 |
hello,
I was trying to mesh a closed loop geometry using extrude block feature in ICEM CFD. But i get some strange errors after i use the O-grid. This is before O-grid Screenshot from 2022-09-21 09-34-16.png, and this is after O-grid Screenshot from 2022-09-21 09-34-30.png. It is supposed to be a single O-grid on that particular surface but unfortunately there are two. what exactly is the problem? regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
dsmcInitialise - dsmcFoam | archymedes | OpenFOAM Pre-Processing | 94 | July 15, 2016 16:14 |
[ICEM] meshing-incomplete mesh in part after moving blocks to separate domains | Mfaizan | ANSYS Meshing & Geometry | 8 | November 29, 2015 21:11 |
[ANSYS Meshing] Difference between merged blocks and adjacent blocks which are not merged | Shruti | ANSYS Meshing & Geometry | 0 | July 12, 2015 17:44 |
[Other] How to create an MRF zone ? | aminem | OpenFOAM Meshing & Mesh Conversion | 2 | December 8, 2014 10:45 |
[snappyHexMesh] Meshing multiple blocks | Hanno | OpenFOAM Meshing & Mesh Conversion | 3 | February 17, 2011 12:14 |