|
[Sponsors] |
[Workbench] Error opening Fluent from Workbench |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 1, 2023, 02:27 |
Error opening Fluent from Workbench
|
#1 |
New Member
Maulana Akbar R
Join Date: Nov 2022
Posts: 7
Rep Power: 3 |
Hi everyone,
I have a project to simulate a 3D Darrieus VAWT. I am using Fluent as the cfd solver. I separated the fluid domain into two parts, the stationary and rotary domain. I use hex dominant method on the stationary domain and multizone method on the rotary. I can mesh the geometry without any problem, the mesh quality is also pretty good. The mesh is shown in figure 1 and 2. The problem starts when i open the Fluent solver, i keep getting the error on figure 3 and 4. If i suppress the rotary domain, the Fluent solver can launch without a problem. Did anyone know what might be the problem? Thank you in advance. Screenshot (850).jpgScreenshot (854).jpgScreenshot (852).jpgScreenshot (853).jpg |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to run fluent from matlab without using aas toolbox? | artemis96 | ANSYS | 7 | May 23, 2022 12:16 |
Sutile and Tricky : Drive Fluent UDF parameters directly from workbench | amscosta | Fluent UDF and Scheme Programming | 4 | July 21, 2020 16:50 |
Starting Fluent in batch mode using Workbench | Gottkanzler | ANSYS | 2 | June 25, 2019 11:37 |
Fluent in Ansys Workbench : Change Working Directory | sral | FLUENT | 4 | March 29, 2019 10:29 |
Setup Cell Error in Fluent on Workbench | tolu | FLUENT | 1 | September 12, 2013 13:28 |