|
[Sponsors] |
[ANSYS Meshing] Mesh Disc Turbine Design - Vertices Association |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 31, 2023, 11:09 |
Mesh Disc Turbine Design - Vertices Association
|
#1 |
New Member
Selina Brinkmann
Join Date: Oct 2022
Posts: 2
Rep Power: 0 |
Good afternoon,
I created a domain (1x1x10m) with a disc and a very simplified turbine body in the middle (see Picture disc). The mesh seems to work for the domain around it and the body of the turbine. However, even though I set the number of nodes to 93, no mesh appears in the ring marking the disc area (pink). The domain I used as an example (inlet_official), shows an association for the vertices with a red arrow at the inlet of the domain. How does this work? There are no points but it seems the vertices are associated (red cross). What does the arrow indicate, a different type of association? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] non uniform mesh near the stl object | vava10 | OpenFOAM Meshing & Mesh Conversion | 0 | January 31, 2021 14:41 |
Star CCM Overset Mesh Error (Rotating Turbine) | thezack | Siemens | 7 | October 12, 2016 11:14 |
3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 06:42 |
[ICEM] Extruded unstructured mesh association with boundaries, volumes, etc. | macfly | ANSYS Meshing & Geometry | 6 | August 7, 2012 16:13 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |