CFD Online Discussion Forums - [BladeModeler] Exporting points in the .rtzt format from DesignModeler/BladeModeler

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)

- ANSYS Meshing & Geometry (https://www.cfd-online.com/Forums/ansys-meshing/)

- - [BladeModeler] Exporting points in the .rtzt format from DesignModeler/BladeModeler (https://www.cfd-online.com/Forums/ansys-meshing/251383-exporting-points-rtzt-format-designmodeler-blademodeler.html)

Exporting points in the .rtzt format from DesignModeler/BladeModeler

I am trying to export the meanline profile of the CAD blade in the .rtzt format that can be read by BladeGen. The ExportPoints options (see picture) in the BladeGen seems to allow exporting the profile in the required format. However, I am unsure what the Blade option highlighted in yellow requires. The turbosystems guide describes this option as below, which is not particularly helpful.

Code:

[Blade feature selection]



Select a blade to indicate the blade row for which data is to be exported

Any advice on how to proceed with this is greatly appreciated. Thanks!