 |
 |
 |
|
|
|
[Sponsors] | ||||
[Other] Why 'Failed to Concatenate Edges' Fault? (Spaceclaim) |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 26, 2024, 04:47
|
Why 'Failed to Concatenate Edges' Fault? (Spaceclaim)
|
#1 |
|
New Member
Join Date: Jan 2024
Posts: 5
Rep Power: 3  |
Hi all,
(Repairing geometry in Ansys Spaceclaim) Is there anyone here that could help me understand the 'Failed to Concatenate Edges' fault message. I have two faults remaining after using the 'Split Edges' repair tool. Is there a simple workaround to resolve this or does the geometry have to be recreated from scratch? Thanks, Martin |
|
|
|
|
|
| Tags |
| failed, repair geometry, repair surface, spaceclaim |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Foam::error::printStack(Foam::Ostream&) with simpleFoam -parallel | U.Golling | OpenFOAM Running, Solving & CFD | 52 | September 23, 2023 04:35 |
| [ANSYS Meshing] Extra edges error in Spaceclaim | Simranjeet Kaur | ANSYS Meshing & Geometry | 0 | July 17, 2021 10:29 |
| addr2line failed error and Segmentation fault error | shivamswarnakar72 | OpenFOAM | 1 | July 5, 2020 07:02 |
| Transient boundary conditions | Jarrod Sinclair (Sinclair) | OpenFOAM Running, Solving & CFD | 133 | May 6, 2015 07:21 |
| OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 14:43 |
Linear Mode
