Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[ANSYS Meshing] Fluent meshing Named_Selections

Mark Forums Read

Reply

Search this Thread

August 12, 2024, 14:47	Fluent meshing Named_Selections	#1
NAWAF New Member Nawaf Join Date: Jun 2022 Posts: 9 Rep Power: 4	Dears, I faced a problem while using fluent meshing. I'm running an external Aerodynamics case. I named general named_selections of the CAD around 8 name_selections, the mesh was generated successfully and took around 5 min for surface mesh and 7 min for volume mesh. When I further divide the same named selections and generate a total of 25 name_selections of the CAD the mesh is taking a lot of time to be generated. Does anyone know why is this happening? Regards,

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Fluent Meshing] Rotating a mesh generated with Fluent Meshing	tinucci	FLUENT	2	April 16, 2024 10:23
[Commercial meshers] Mesh Quality - Fluent Meshing, ANSA	cweisheng	OpenFOAM Meshing & Mesh Conversion	0	November 15, 2023 02:33
[ANSYS Meshing] Defining a cell zone in ANSYS meshing for fluent	Stephen Waite	ANSYS Meshing & Geometry	1	July 4, 2022 09:21
Transfer named selections from SW to Fluent Meshing	the-sted	FLUENT	0	May 1, 2016 23:44
Toolbars of Graphic windows in Fluent Meshing	Sina.Li	FLUENT	1	December 28, 2015 01:09

All times are GMT -4. The time now is 21:14.