|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Patricia Jones
Join Date: Jan 2025
Posts: 1
Rep Power: 0 ![]() |
Hello, I am working on a plane design but when I plug my geometry to ansys and use the automatic meshing, it raises an error and when I click on show problematic geometry, it shows me the sharp corners on the trailing edge junction between two boards. I figured that smoothing them out would remove the problem but again, it is important to keep them sharp for other design constraints. I added a visual of the problematic area for a clearer understanding.
Any advice? Thanks in advance! |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
ANSYS meshing vs FLUENT meshing | breznak | Main CFD Forum | 2 | January 13, 2025 01:02 |
Ansys Installation on Docker Container | mohsen.shiea | ANSYS | 11 | March 14, 2024 12:18 |
[Gmsh] gmshToFoam generates patches with 0 faces and 0 points | Simurgh | OpenFOAM Meshing & Mesh Conversion | 4 | August 25, 2023 08:58 |
[Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 11:49 |
[ANSYS Meshing] Problem with ANSYS Meshing - how to refine? | pyroknife | ANSYS Meshing & Geometry | 2 | August 22, 2013 14:30 |