 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] wbu.exe crashes, file not found but it exists |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 19, 2025, 01:29
|
wbu.exe crashes, file not found but it exists
|
#1 |
|
Senior Member
Join Date: May 2012
Location: Melbourne
Posts: 163
Rep Power: 15  |
Good day,
installed Ansys 2025. Just modeled a simple box ( so its not the geometry) and when I go to the mesher, it crashes. Unable to attach to geometry file F:\Data\Ansys\box3_files\dp0\CFX\DM\CFX.agdb. Either the application crashed or Workbench lost communication with it. the box actually shows in the mesher. And the file CFX.agdb is actually in that specified folder in F:\ I tried this https://innovationspace.ansys.com/fo...-been-written/ but no change edit: clean re-install did not help Last edited by Steffen595; September 19, 2025 at 06:23. |
|
|
|
|
|
October 8, 2025, 06:54
|
|
#2 |
|
New Member
DeloresPacocha
Join Date: Oct 2025
Posts: 1
Rep Power: 0 |
Is your error resolved?
|
|
|
|
|
|
|
October 8, 2025, 07:33
|
|
#3 |
|
Senior Member
Join Date: May 2012
Location: Melbourne
Posts: 163
Rep Power: 15 |
|
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trouble compiling utilities using source-built OpenFOAM | Artur | OpenFOAM Programming & Development | 14 | October 29, 2013 11:59 |
| centOS 5.6 : paraFoam not working | yossi | OpenFOAM Installation | 2 | October 9, 2013 02:41 |
| [swak4Foam] Error bulding swak4Foam | sfigato | OpenFOAM Community Contributions | 18 | August 22, 2013 13:41 |
| OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3 | flakid | OpenFOAM Installation | 16 | December 28, 2010 09:48 |
| Version 15 on Mac OS X | gschaider | OpenFOAM Installation | 113 | December 2, 2009 11:23 |
Linear Mode
