Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

Check the skewnesses of your face meshes and make sure the face mesh sizes are not to

Mark Forums Read

Reply

Search this Thread

April 13, 2009, 17:27	Check the skewnesses of your face meshes and make sure the face mesh sizes are not to	#1
sophie-l New Member sophie Join Date: Apr 2009 Posts: 8 Rep Power: 17	hi, i am trying to mesh a big cylinder with an other small one that is tangentiel to the first. I can mesh the big one without problems, but when i try to mesh the small one the following message of error is given by gambit: Check the skewnesses of your face meshes and make sure the face mesh sizes are not too large in areas of samll gaps what should i do? thanks sophie

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Getting prism to inflate into mixed tet-hex meshes	Joe	CFX	16	October 10, 2011 07:06
Check the skewnesses of your face meshes and make sure the face mesh sizes are not to	sophie-l	Main CFD Forum	1	April 13, 2009 19:16
2d irregular grid	Remy	Main CFD Forum	1	December 22, 2008 04:49
Fluent 6.3.16 + Polyehdral Meshes	Carlos	FLUENT	3	March 15, 2007 03:09
meshing F1 front wing	Steve	FLUENT	0	April 17, 2003 12:37

All times are GMT -4. The time now is 04:06.