|May 25, 2009, 15:07||
Mesh Quality in Gambit using Pro E Imports!!
Join Date: Apr 2009
Location: London UK
Posts: 4Rep Power: 10
I am working on a project to simulate the flow of water through a water deaerator. This was modeled with Pro E Wildfire Version 2 and subsequently I imported intop Gambit as a STEP file and deleted the redundant volumes.
I then merged faces (Virtual - Tolerance with min angle 160) and created size functions to improve the mesh quality.
However, even though the model looks meshed, upon inspection of the mesh, the total number of elements is equal to 0.
I am not too sure what is happeening. Would appreciate if someone can help please.
|Thread||Thread Starter||Forum||Replies||Last Post|
|3-d mesh gambit (cylinder within a cylinder)||Jason||ANSYS Meshing & Geometry||29||October 30, 2015 09:59|
|Pro E Imports in Gambit||Andrew Fsadni||ANSYS Meshing & Geometry||21||August 8, 2011 02:05|
|increasing mesh quality is leading to poor convergence||tippo||CFX||2||May 5, 2009 10:55|
|Icemcfd 11: Loss of mesh from surface mesh option?||Joe||CFX||2||March 26, 2007 18:10|
|3-D Mesh Check in Gambit.....||SHR||FLUENT||4||March 25, 2003 04:10|