|
[Sponsors] |
[ANSYS Meshing] "Uncovered faces" when refining |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 20, 2016, 18:21 |
"Uncovered faces" when refining
|
#1 |
New Member
Sergio
Join Date: May 2015
Posts: 10
Rep Power: 10 |
Hello all,
I am meshing an 2D Pipe Junction in ICEM. I had no problems when I did the tutorial but when I tried to refining the mesh in one block (blocking>Pre-mesh params>Refinement (level 2)) I get the error that is shown in the picture. I created a new subset as the message says but Fluent can't open the mesh... Does Anyone know how to solve it? Last edited by smb; March 21, 2016 at 04:37. |
|
March 29, 2016, 03:19 |
|
#2 |
Senior Member
Paritosh Vasava
Join Date: Oct 2012
Location: Lappeenranta, Finland
Posts: 732
Rep Power: 22 |
Is that Ansys meshing or ICEM?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Refining only a portion of a mesh | wagnerzs | OpenFOAM | 0 | June 24, 2014 09:46 |
[snappyHexMesh] snappyHexMesh not refining surfaces | Hydro1004 | OpenFOAM Meshing & Mesh Conversion | 3 | August 29, 2012 11:56 |
Refining mesh along an edge at an intersection ? | mmn1239 | STAR-CCM+ | 5 | April 11, 2012 14:39 |
[ANSYS Meshing] "uncovered faces" | CRT | ANSYS Meshing & Geometry | 6 | March 23, 2012 11:38 |
Refining mesh | Atholl | FLUENT | 2 | February 19, 2002 06:38 |