CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ICEM] how to mesh 3D wing at icem cfd (

agungwp June 16, 2009 03:35

how to mesh 3D wing at icem cfd
i wanna generate grid at 3D wing in icem cfd. there are any problem with mesh quality at trailing edge. any hole along trailing edge. the planform for my model is refered to B777 wing. why the mesh quality in trailing edge like those?

see the picture in address below:

PSYMN June 17, 2009 11:02

Thin Cuts or Edge Criterion
This is due to the way the OCtree process can sometimes jump between close surfaces.

It can be prevented with the "thin cuts" setting or by reducing the edge criterion, both of these are under Global Mesh params.

All times are GMT -4. The time now is 00:59.