 |
 |
 |
|
|
|
[Sponsors] | ||||
June 22, 2009, 16:43
|
Turbomachinery Blade Passage Creation
|
#1 |
|
Member
Sherif Kadry
Join Date: May 2009
Posts: 38
Rep Power: 18  |
Hello everyone,
I have a 3D stator and rotor blade design as well as a 3D solidworks model for an axial turbine setup. I have ANSYS CFX (turbogrid included), and ICEMCFD at my disposal. I was looking for tips to create the blade passage geometry without having to resort to turbogrid. So that I can take the blade passage geometry into ICEMCFD and mesh it in there. Thank you. Sherif |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Meshing turbomachinery blade domain in Gridgen | Hasham H Chougule | Pointwise & Gridgen | 0 | September 3, 2007 09:33 |
| Flow study through Turbine Blade passage | Subrata | FLUENT | 1 | May 4, 2007 12:28 |
| BCs for a turbine blade passage | Babu | FLUENT | 0 | December 12, 2006 12:25 |
| how to do this turbine blade passage flow nanlysis | kaen | CFX | 0 | January 17, 2006 23:50 |
| how to do blade passage analysis of turbine? | kaen | FLUENT | 0 | January 17, 2006 23:49 |
Linear Mode
