 |
 |
 |
|
|
|
[Sponsors] | ||||
July 6, 2009, 05:46
|
Periodicity Problems
|
#1 |
|
New Member
Join Date: Jul 2009
Posts: 2
Rep Power: 0  |
Hello,
i am trying to create a periodic mesh hexcore mesh with prisms. When creating the tretra mesh first, no periodic problems occur. But after introducing prisms the periodicity is disturbed. Only 7 cells out of 1 million, but Fluent wont work with this seven cells. Can anybody help me? |
|
|
|
|
|
July 7, 2009, 10:26
|
non periodic part names.
|
#2 |
|
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
What tool are you using?
If it is ICEM CFD, the nodes may be aligned, but the parts different (since part inheritance is not controlled by the periodicity settings.) If you have seven nodes that are not periodic, check their part names (perhaps a few points or a short curve segment is in the wrong part). You may just need to change part on those elements to proceed. You may as well also change the part of the underlying entities. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Needed Benchmark Problems for FSI | Mechstud | Main CFD Forum | 4 | July 26, 2011 12:13 |
| Periodicity in CFX | Sam S | CFX | 2 | August 27, 2007 00:59 |
| Problems with periodicity (ProE-ICEM) | Danny | CFX | 3 | December 11, 2006 09:13 |
| translational periodicity | wasim | CFX | 0 | May 13, 2006 13:34 |
| Some problems with Star CD | Micha | Siemens | 0 | August 6, 2003 13:55 |
Linear Mode
