Kindly asking help about "unfilted mesh" in Gambit
 

When I export a mesh file , it warns : At least one geometry entity has no mesh for export . You can use the "Unmeshed" filter in the geometry summarize picker to find the unmeshed entitied.

Then I did use unmeshed picker to check all the volumes, I don't think there is one of them unmeshed. Also it seems ok when i input the mesh in to Fluent. (It runs properly)

Is there any one could give me some guide lines? Thanks a lot!

C.J

you may apply this filter for volume and also surface.
maybe you defined a standalone surface, which doesn t belong to any volume.
That's why you can run your mesh properly.

Thanks MAX. That is probably the problem. I will check it now~ :D

I am new user of Fluent , even don't know how to say Thank you in the right place.

""
Thanks MAX. That is probably the problem. I will check it now~ :D

Gambit export error
 

I am new to Gambit software. When I am exporting the geometry, I am getting a warning saying as "At least one geometry entity has no mesh for export," but all the parts of my geometry has a meshing.

Can anybody help me out with this


Thanks in advance