|
[Sponsors] |
August 13, 2009, 10:38 |
Blade meshing in ICEM CFX
|
#1 |
New Member
Pawel Korsunskiy
Join Date: Aug 2009
Posts: 1
Rep Power: 0 |
hello everybody,
i am beginner in ICEM CFX. Can somebody help me with Blade meshing? After Repair Geometry -> Build Topology I get 2 blue lines (link). If i ignore them and build mesh, cfx solver show Error 'Overflow'. How can I repair these blue lines? thank you Pawel http://www.bilderhoster.at/estqb1250170479.html |
|
August 14, 2009, 04:14 |
|
#2 |
New Member
Join Date: Aug 2009
Posts: 10
Rep Power: 17 |
Hi,
check end points of these curves, and fix by addition or delete splines and lines. |
|
August 20, 2009, 19:05 |
Red Herring, Blue Herring.
|
#3 |
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
Blue lines just mean a multiple edge in the geometry... It may be perfectly valid depending on your model. After you mesh, you may not even get a multiple edge if you didn't mesh on both sides of the "T".
I don't think they are directly responsible for an "overflow" error. I am not a CFX expert, but I think that is a memory error. you should ask the question on the CFX solver side of CFD-Online. Simon |
|
August 5, 2010, 18:19 |
|
#4 | |
Senior Member
Saima
Join Date: Apr 2009
Location: Canada
Posts: 185
Rep Power: 16 |
Could you please tell me the steps for the blade meshing, i will be very thankfull to u.
Quote:
|
||
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Import Mesh from ICEM CFD to CFX | Andre Almeida | CFX | 16 | April 19, 2016 04:42 |
ICEM for CFX | Al Mazdeh | CFX | 7 | April 5, 2008 07:32 |
ICEM Meshing | Jaloha | CFX | 0 | April 1, 2008 07:24 |
Question on blade meshing | Jeffrey | CFX | 0 | March 7, 2008 18:13 |
importing mesh from ICEM CFD into CFX 5 | Jay | CFX | 2 | November 12, 2002 14:46 |