creating mesh from scratch

tosif · August 25, 2009, 23:32

Can anyone guide me how to create a mesh for air duct with reducers and elbows, to be used in fluent 3D.

PSYMN · August 27, 2009, 12:23

That is a broad question...

What software are you using? Have you tried any of its related tutorials?

If you are looking for a software, you could try ANSYS Meshing if the geometry is straight forward enough.

Try ICEM CFD if you think it is more complicated or you are starting with poor or faceted geometry.

Simon

tosif · August 31, 2009, 22:03

thanks simon,

we are using ansys workstation. can i use turbo grid for that purpose?

mach13 · September 6, 2009, 13:14

U can start by seeing the modeling guide of gambit (assuming u are using Gambit) - 'meshing the geometry' section. This is a part of gambit documentation. Then u can try various schemes like :-
(i) Cooper for the duct volume or
(ii) Generate a face mesh followed by volume mesh.

All depends on ur PC viability and memory requirements.

August 25, 2009, 23:32	creating mesh from scratch	#1
tosif New Member tosif Join Date: Aug 2009 Posts: 4 Rep Power: 16	Can anyone guide me how to create a mesh for air duct with reducers and elbows, to be used in fluent 3D.

August 27, 2009, 12:23	Tutorials?	#2
PSYMN Senior Member Simon Pereira Join Date: Mar 2009 Location: Ann Arbor, MI Posts: 2,663 Blog Entries: 1 Rep Power: 47	That is a broad question... What software are you using? Have you tried any of its related tutorials? If you are looking for a software, you could try ANSYS Meshing if the geometry is straight forward enough. Try ICEM CFD if you think it is more complicated or you are starting with poor or faceted geometry. Simon

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] vtk mesh or Abaqus mesh to OpenFOAM	bigphil	OpenFOAM Meshing & Mesh Conversion	27	November 23, 2015 17:31
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 14:11
Creating a hemisphere mesh	Danny Ditroia	Phoenics	1	May 6, 2008 15:50
creating a boundary layer mesh	SANAT DAS	FLUENT	1	August 11, 2005 12:57
creating mesh using Gambit	Rucy Hong	FLUENT	3	April 26, 2005 23:27

August 31, 2009, 22:03		#3
tosif New Member tosif Join Date: Aug 2009 Posts: 4 Rep Power: 16	thanks simon, we are using ansys workstation. can i use turbo grid for that purpose?

September 6, 2009, 13:14		#4
mach13 New Member mach Join Date: Sep 2009 Location: India Posts: 11 Rep Power: 16	U can start by seeing the modeling guide of gambit (assuming u are using Gambit) - 'meshing the geometry' section. This is a part of gambit documentation. Then u can try various schemes like :- (i) Cooper for the duct volume or (ii) Generate a face mesh followed by volume mesh. All depends on ur PC viability and memory requirements.