|September 16, 2009, 17:42||
How can make a 2D geometry DesignModeler?
Abraham Jaimes Hernandez
Join Date: Sep 2009
Location: Mexico City
Posts: 6Rep Power: 9
I am working with ANSYS 12. The 2D geometries made in Design Modeler are not recognized by the application Meshing (appears "?Geometry" in the tree outline).
How to solve the problem?
|September 17, 2009, 14:32||
A picture is worth a thousand words, here is 2k.
Retired from CFD Online
Join Date: Mar 2009
Location: Ann Arbor, MI
Blog Entries: 1Rep Power: 39
Here you go...
Just right click on the geometry field on the project schematic, then set the Analysis type to 2D.
|ansys 12, geometry|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Simulation of Flow through Complex 3D Geometry||EmersonKB||CFX||5||July 2, 2009 08:17|
|ICEM: Holes in Geometry||Daniel||CFX||4||February 22, 2009 10:40|
|[OFF] Geometry on SolidWorks as input of ANSYSCFX||Rogerio Fernandes Brito||CFX||0||July 12, 2008 11:20|
|make a chart in CFX-POST||Alessandro||CFX||1||March 4, 2008 17:24|
|[Q]How to make MPEGs with CFD datas???||Bum-Seok Hyun||Main CFD Forum||4||February 16, 2000 19:59|