CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   highly skewed elements in grid (

ryan November 30, 2009 15:56

highly skewed elements in grid
I was trying to mesh a face with around a 2d airfoil.But after meshing the face it shows that i have 18 highly skewed elements.How do i remove them.

Suvash Saha December 2, 2009 00:18

I am also facing the same problem. Anybody here to help?

Suvash Saha December 2, 2009 02:24

I have found a way. However, I don't know whether it is right way or not! Just go to Grid->Polyhedra->Convert Skewed Cells. I found it in the UG of fluent.

-mAx- December 2, 2009 03:41

there is always a reason for skewed cells.
Try to found this reason (small edge, small angle etc...)
If you don't see any geometrical reason, then try to "play" with mesh parameters (size function etc....)

All times are GMT -4. The time now is 02:14.