 |
 |
 |
|
|
|
[Sponsors] | ||||
[TGrid] overlapping problem for stator and rotor blade |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 1, 2010, 01:31
|
overlapping problem for stator and rotor blade
|
#1 |
|
New Member
kennethtuba
Join Date: Dec 2009
Posts: 1
Rep Power: 0  |
Hi all,
I have a problem with compressor rotor and stator blade when combining both as one stage in an axial compressor design. When I try to open profile.curve for my stator as Blade 2 ( rotor as Blade 1 in Objects treeview> Blade set), the error message come out on my computer screen such as below . ERROR Detected non-overlapping blades. Overlapping blades are required to calculate periodic interface. Hopes somebody can help me to solve this problem. Thanks. Kenneth |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
| Incoherent problem table in hollow-fiber spinning | Gianni | FLUENT | 0 | April 5, 2008 10:33 |
| natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
| convergence problem | Trushar | Phoenics | 5 | August 27, 2002 23:40 |
Linear Mode
