[ICEM] mesh creation

Birkov · February 3, 2010, 09:02

Hi to all,

I have question about mesh creation. I imported data from STL (box in box) file to ICEM. I would like to create mesh only between boxes (not in box inside) but I can't figure out how to do it. I checked manual and there is almost what I want, but only if I want just box inside all everythink.
Can anybody help?

Thank you very much.

B.

EDIT: I tried different file type (parasolid) and it works how I expected. But if it's any way how to solve problem which I described I will be happy. Thank you.

rwryne · February 3, 2010, 09:40

Make sure you create a material body within the area you want to be meshed. (It is the button to the right of the mesh button in the Geometry tab)

Birkov · February 3, 2010, 10:00

As I wrote I chose different file format and it works. I will continue on this way.
Thanks for quick reply.

February 3, 2010, 09:02	mesh creation	#1
Birkov New Member Join Date: Jul 2009 Location: Prague Posts: 28 Rep Power: 0	Hi to all, I have question about mesh creation. I imported data from STL (box in box) file to ICEM. I would like to create mesh only between boxes (not in box inside) but I can't figure out how to do it. I checked manual and there is almost what I want, but only if I want just box inside all everythink. Can anybody help? Thank you very much. B. EDIT: I tried different file type (parasolid) and it works how I expected. But if it's any way how to solve problem which I described I will be happy. Thank you. Last edited by Birkov; February 3, 2010 at 09:43.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dynamic Mesh Problem.	Tom Clark	FLUENT	10	June 21, 2021 05:27
Meshing aifoil in ICEM	student123a	ANSYS Meshing & Geometry	13	December 8, 2010 11:40
problem when converting mesh (made by ICEM) using fluentMeshToFoam	Forrest_Lei	OpenFOAM	11	October 16, 2009 07:28
2d irregular grid	Remy	Main CFD Forum	1	December 22, 2008 05:49
General questions on grid-based computing	Adrin Gharakhani	Main CFD Forum	21	June 5, 2000 14:47

February 3, 2010, 09:40		#2
rwryne Senior Member Ryne Whitehill Join Date: Aug 2009 Posts: 312 Rep Power: 20	Make sure you create a material body within the area you want to be meshed. (It is the button to the right of the mesh button in the Geometry tab)

February 3, 2010, 10:00		#3
Birkov New Member Join Date: Jul 2009 Location: Prague Posts: 28 Rep Power: 0	As I wrote I chose different file format and it works. I will continue on this way. Thanks for quick reply.