|
[Sponsors] |
March 30, 2010, 09:04 |
mesh problem
|
#1 |
Member
Join Date: Oct 2009
Location: Italy
Posts: 88
Rep Power: 16 |
Hi everyone,
i have a problem with mine mesh. The geometry is a cube where inside there are a circular hole. In the summit of a cube i have a split so when i'm going to meshing the volume with a cooper schem i have an error for this split. is there a method for meshing the volume without doing a split in lower surface of cube? thanks for any suggeston |
|
March 30, 2010, 12:50 |
|
#2 | |
Senior Member
Chris
Join Date: Jul 2009
Location: Ohio, USA
Posts: 169
Rep Power: 16 |
Quote:
cube-with-hole-01.PNGcube-with-hole-02.jpg All faces are meshed with a structured mesh. For some of the faces (see the picture,) you need to change one vertex from "end" to "side", because the quad:map scheme requires the number of end verticies on a face to be equal to four. |
||
March 31, 2010, 02:55 |
|
#3 |
Member
Join Date: Oct 2009
Location: Italy
Posts: 88
Rep Power: 16 |
the problem is showing in the second picture. i have a similar geometry, but the volume that not have the mesh in picture in my case there aren't a split so is a simple cube.
for resolve the problem i do the split this cube or there is a method for meshing without it. |
|
March 31, 2010, 08:08 |
|
#4 |
Senior Member
Chris
Join Date: Jul 2009
Location: Ohio, USA
Posts: 169
Rep Power: 16 |
Hmm, I'm not sure if I understand. In you case, does the circular hole go completely through the cube? Maybe if you posted a picture the problem would be more clear.
|
|
March 31, 2010, 10:45 |
|
#5 |
Member
Join Date: Oct 2009
Location: Italy
Posts: 88
Rep Power: 16 |
thank you chris i have resolved the problem !!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic Mesh Problem. | Tom Clark | FLUENT | 10 | June 21, 2021 04:27 |
[GAMBIT] Problem with mesh. Please Help... | maziboss | ANSYS Meshing & Geometry | 1 | September 28, 2009 02:24 |
mesh generation problem | Ellen | FLUENT | 7 | February 18, 2009 21:20 |
mesh control problem | TUM | CFX | 4 | July 27, 2001 16:17 |
Convergence problem when ustructured mesh is used. | SangJin Ryu | Siemens | 3 | October 5, 2000 20:26 |