|
[Sponsors] |
April 9, 2010, 16:14 |
How to create a 3d pipe in Gmbit
|
#1 |
New Member
Eng. Yaser
Join Date: Apr 2010
Posts: 1
Rep Power: 0 |
Hi everyone,
I need to model a vein in order to make further studying about the blood flow in veins with and without deformation. So, I need a help in creating a 3D pipe in Gambit and what is the best meshing? I know how to create a 2D model but not 3D. Thanks |
|
April 12, 2010, 01:25 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
if your section is constant, then you can extrude your face with help from an curve (for instance) --> Sweep Faces
Regarding Meshing, Cooper should be a good alternative
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
create patch to obtain annular pipe | nikwin | OpenFOAM | 0 | January 4, 2010 02:56 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |