[ICEM] ICEM CFD Boundary Conditions not found in Ansys Fluent

sammyraj · April 9, 2010, 17:11

Hi all,

I am doing a 2 D project which involves flow through two annular nozzles. I am new to ICEM CFD and I have simple problem.And help will be much appreciated.

I created geomtry and also meshing. Also I gave BC's in icem cfd and when I tried to read the mesh in Ansys fluent ,the BC's were not found. Fluent was able to read the mesh but not the B.C's. I have given Bc's by creating new part and giving names.

rwryne · April 12, 2010, 08:28

You have to assign actual boundary conditions to your named parts.

Follow the steps in this post: http://www.cfd-online.com/Forums/ans...tml#post230872

sammyraj · April 12, 2010, 15:23

Hi Ryne,

Thanks a lot!!
I should have searched the forums before asking and I think I assigned B.c's after meshing. So I am gonna change that.

anyways please allow me ask one more question .
I have solve a problem which involves flow through two annular nozzles, I am not sure about mesh yet although I was able to read in Fluent. Can you guide me the best way to mesh also creating surfaces

April 9, 2010, 17:11	ICEM CFD Boundary Conditions not found in Ansys Fluent	#1
sammyraj New Member raj Join Date: Feb 2010 Location: OKlahoma Posts: 13 Rep Power: 16	Hi all, I am doing a 2 D project which involves flow through two annular nozzles. I am new to ICEM CFD and I have simple problem.And help will be much appreciated. I created geomtry and also meshing. Also I gave BC's in icem cfd and when I tried to read the mesh in Ansys fluent ,the BC's were not found. Fluent was able to read the mesh but not the B.C's. I have given Bc's by creating new part and giving names.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problems in compiling paraview in Suse 10.3 platform	chiven	OpenFOAM Installation	3	December 1, 2009 07:21
Installation OF1.5-dev	ttdtud	OpenFOAM Installation	46	May 5, 2009 02:32
prob while exporting icem cfd hexa mesh to fluent	mani	CFX	4	March 7, 2007 03:41
Boundary conditions?	Tom	Main CFD Forum	0	November 5, 2002 01:54
Boundary conditions in Fluent 4.5	Arturo Ortiz	FLUENT	0	January 25, 2001 17:52

April 12, 2010, 08:28		#2
rwryne Senior Member Ryne Whitehill Join Date: Aug 2009 Posts: 312 Rep Power: 18	You have to assign actual boundary conditions to your named parts. Follow the steps in this post: http://www.cfd-online.com/Forums/ans...tml#post230872

April 12, 2010, 15:23		#3
sammyraj New Member raj Join Date: Feb 2010 Location: OKlahoma Posts: 13 Rep Power: 16	Hi Ryne, Thanks a lot!! I should have searched the forums before asking and I think I assigned B.c's after meshing. So I am gonna change that. anyways please allow me ask one more question . I have solve a problem which involves flow through two annular nozzles, I am not sure about mesh yet although I was able to read in Fluent. Can you guide me the best way to mesh also creating surfaces