|May 10, 2010, 14:30||
Setting Boundary Conditions
Join Date: May 2010
Posts: 15Rep Power: 8
I'm following this tutorial ( https://confluence.cornell.edu/displ...pe+Flow+Step+3 ) which was written for Gambit. I am working in ICEM. I can't figure out how to apply the boundary conditions (velocity inlet, pressure outlet, axis wall).
I set my solver to Fluent 6, and went to Output --> Boundary Conditions. In this window, I went to Mixed/Unknown-->GEOM-->Create New, and created the boundary condition "velocity inlet" and it asked me to specify a zone. I don't know what the zones are, or how to specify them. Thanks for your time.
|June 8, 2010, 20:29||
Retired from CFD Online
Join Date: Mar 2009
Location: Ann Arbor, MI
Blog Entries: 1Rep Power: 39
Just ignore the zones (leave them as zero). Those get more important if you are doing fancy things such as a rotating zone within a static zone...
If they are all set to zero, then they are all part of the same zone (zone 0, the default zone).
|Thread||Thread Starter||Forum||Replies||Last Post|
|Impinging Jet Boundary Conditions||Anindya||Main CFD Forum||25||February 27, 2016 13:58|
|symmetry boundary conditions in cfx||lost.identity||CFX||41||May 22, 2013 07:21|
|mesh file for flow over a circular cylinder||Ardalan||Main CFD Forum||6||April 17, 2010 23:40|
|question setting up airfoil Boundary Conditions||ibzyuk||FLUENT||0||April 9, 2010 07:47|
|Concentric tube heat exchanger (Air-Water)||Young||CFX||5||October 6, 2008 23:17|