|June 10, 2010, 05:53||
How to divide a surface?
Join Date: Jun 2010
Posts: 4Rep Power: 8
Hello to everyone!
Does anybody of you know how to split/divide a surface?
To better say: I have a body with a hole inside; the surface of the body that is in contact with the hole, i want to divide it in two part...because then...when I will set the boundaries condition, i want to give to these two different part of the same surface, 2 different setting.
Is it possible?
thank you very much...I really need your help!!!!
|June 10, 2010, 08:22||
Join Date: Mar 2009
Location: Berlin, Germany
Posts: 446Rep Power: 13
For WB mesher --> draw the circle whereever you want to have it and extrude it by imprinting surfaces; you have to unfreeze the "imprintable" body before.
For ICEM --> draw the circel.... and then just cut the face by curve and add a new part for the "circlesurface"
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] surface mesh merging problem||everest||ANSYS Meshing & Geometry||44||April 14, 2016 06:41|
|Error : Self intersecting surface mesh, computing intersections & Error : Impossible||velan||Open Source Meshers: Gmsh, Netgen, CGNS, ...||3||October 22, 2015 11:05|
|Problem with Gmsh||nishant_hull||Open Source Meshers: Gmsh, Netgen, CGNS, ...||23||August 5, 2015 02:09|
|boundaries with gmshToFoam||ouafa||Open Source Meshers: Gmsh, Netgen, CGNS, ...||7||May 21, 2010 12:43|
|CFX4.3 -build analysis form||Chie Min||CFX||5||July 12, 2001 23:19|